RazoRock BBS AS Base Plate: What It Does for Your Shave
By Italian Barber Online Shaving Supplies – ItalianBarber | Published: 2026-10-25
Category: How-to Guides
Learn how the RazoRock BBS AS base plate changes your shave, who it suits, and step-by-step tips for using this aggressive stainless steel base.
Quick answer
The RazoRock BBS AS base plate delivers a very smooth, efficient shave by increasing blade exposure and blade gap compared to milder plates. It works best for experienced wet shavers who want a close shave with fewer passes.
Why the BBS AS base plate is different
The BBS AS (Advanced Shave) base plate uses a more aggressive geometry than the standard BBS plate. Testers report it as one of the smoothest shavers they've used, largely because of the precise blade angle and exposure. The stainless steel construction adds weight and durability, which helps the razor glide without extra pressure.
This base plate is sold separately—you need to already own a BBS top cap. If you already have a BBS razor, swapping just the base plate is a cost-effective way to try a more aggressive shave without buying a whole new razor.
Who should consider the AS base plate
This plate suits wet shavers with a few months of experience who find milder razors require too many passes. It's also a good fit if you have coarse or dense hair and want a single-pass reduction. However, if you have very sensitive skin or are new to safety razors, start with a milder base plate first.
How to shave with the BBS AS base plate
- 1. Load the blade correctly: Place the blade on the BBS top cap, then align the AS base plate so the blade tabs are even on both sides. Tighten the handle just until snug—overtightening can warp the blade. Check blade alignment before each shave; a misaligned blade can cause nicks.
- 2. Use a shallow angle: Hold the handle nearly parallel to your skin (about 30 degrees). The AS plate's increased blade exposure means a steep angle will feel harsh. Let the razor's weight do the cutting. If you feel tugging or scraping, you're likely using too steep an angle.
- 3. Shave with short, light strokes: Use strokes about 1–2 inches long. Do not apply pressure—the extra blade gap and exposure will cut hair efficiently on its own. Rinse the blade after every two strokes. Pressuring the razor is the most common mistake with aggressive plates; it causes irritation and razor burn.
- 4. Limit passes to two: Start with a with-the-grain pass, then do a cross-grain pass if needed. Avoid against-the-grain on the first few shaves. The AS plate is efficient enough that two passes often deliver a near-BBS result. If you feel stinging or redness, stop after one pass and assess your skin.
- 5. Rinse and dry the base plate: After shaving, rinse the base plate under warm water and pat it dry with a soft cloth. Stainless steel resists corrosion, but soap scum can build up in the blade channels over time. A quick dry prevents mineral deposits and keeps the plate looking new.
Product facts
- RazoRock Stainless Steel BBS "AS" Base Plate: The RazoRock BBS AS base plate is made of stainless steel and is sold as the base plate only—you must already own a BBS top cap. This means you can upgrade your existing BBS razor to a more aggressive shave without buying a complete new razor, saving money and reducing waste.
RazoRock Stainless Steel BBS "AS" Base Plate
