Start with one blade, not the whole pack
The Gillette Nacet Stainless Double Edge Razor Blades arrive as two packs of five, ten blades in total. Open one tuck, take out a single blade, and leave the rest wrapped. A first shave is a test of how the blade feels in your razor and on your face, so there is no reason to unwrap more than you need.
The listing describes these as long lasting stainless steel blades made in Saint Petersburg, Russia, and calls them a combination of sharpness and smoothness. Treat that as the manufacturer's description, not a promise about how your skin will react. Your job on the first shave is to load the blade correctly, keep the angle steady, and notice what your face tells you.
What the Nacet listing confirms
- 10 Gillette Nacet Stainless Double Edge Razor Blades: 10 Gillette Nacet Stainless Double Edge Razor Blades, supplied as 2 packs of 5 blades each. You can test one blade and still have nine left, so a single rough shave does not waste the pack.

10 Gillette Nacet Stainless Double Edge Razor Blades - 10 Gillette Nacet Stainless Double Edge Razor Blades: Long lasting stainless steel. Stainless steel is the material named in the listing; the catalog does not state a specific number of shaves per blade.
- 10 Gillette Nacet Stainless Double Edge Razor Blades: Made in Saint Petersburg, Russia. This is the stated origin, useful if you track where your blades are made.
Loading the blade and setting up the first shave
The supplied information does not include a step-by-step loading procedure, so follow the instructions that came with your safety razor. The points below are general handling habits, not manufacturer instructions for the Nacet blade.
- Work over a surface you can clean: Unwrap one blade over a sink or a towel so a dropped blade does not travel. DE blades have two sharp edges, so hold the blade by its ends and keep your fingers away from the edges.
- Seat the blade in your razor: Follow your razor's own instructions for aligning the blade and tightening the head. Check that the blade sits evenly before you shave; an unevenly seated blade is a setup problem, not a blade problem.
- Start with a light lather and a short first pass: Shave a small area first, such as one cheek, rather than committing to a full three-pass shave. This gives you a read on the blade before you finish.
- Keep the angle shallow and the pressure light: The catalog does not specify a shave angle for these blades. Use the angle your razor's design calls for, and let the blade do the cutting rather than pressing it into your skin.
Checkpoints after the first pass
The Nacet listing says the blade combines sharpness and smoothness, but it does not provide a break-in period or a recommended number of shaves. Use these checkpoints to judge the first shave on your own terms.
- Did the blade cut evenly?: Patchy cutting can point to a blade that is not seated correctly or a razor head that is not tightened. Recheck the loading before you blame the blade.
- Did you feel tugging or scraping?: If the first pass felt rough, reduce pressure and shorten the stroke before you change anything else. The catalog does not state a shave count for this blade, so there is no official point at which roughness means the blade is spent.
- Any nicks or irritation?: Stop and finish with your usual post-shave routine. The supplied information does not include aftercare instructions for this blade, so use products and habits you already know suit your skin.
- Would you use it again tomorrow?: The listing does not give a replacement schedule. Judge by comfort and cut quality, and replace the blade when either drops, following your razor maker's guidance on blade handling.
Why the 10-pack suits a first trial
A ten-blade pack gives you room to test the Nacet blade across several shaves without opening a bulk order. The listing calls these blades hard to find, so if the first shave suits you, the two five-blade tucks are easy to store and rotate. Keep the unopened tuck dry and out of reach of children, and do not unwrap a second blade until you are ready to use it.
The catalog does not state how many shaves each blade lasts, what razors it fits beyond standard double edge compatibility, or whether it is coated. Those are open questions in the supplied information, so base your decision on your own first shave rather than on a promised lifespan.

